Swamp Cooler Water Line Connection

Bonaire durango how to quick connect water supply line to your evaporative swamp cooler.

Swamp cooler water line connection.

Brass sill cock with 1 8 in. An install kit uses a screw on attachment that can go to any standard water faucet. Yep the float is at least 3 4 below the overflow tube. Here are a few ways it can be done.

Lay out the supply line either copper or plastic and connect one side to the hose bib valve. If you ve inpected the cooler basin and all then yes you ll have to trace back the water line. 25 ft length of poly tube brass sill cock w hose thread and 1 8 in. The way to keep it simple is to buy an evaporative cooler water hook up kit.

Connect the other end of the water tubing to either the fitting on the outdoor faucet or the saddle valve depending on the one you are using for your water source. They work by screwing on to the existing faucet and adding a second faucet for a hose and a side mount for the swamp cooler line to connect to. Cc x 1 8 in. 2 brass adapters to connect poly tube to compression fittings overview this kit contains everything needed need to run a water line to an evaporative cooler.

Either type of connection will require the same steps as the connection to the swamp cooler. Use a swamp cooler install kit. Poly tube with 2 brass adapters. Turn on the water and check for leaks.

Side tap 1 4 in. Connecting a water line to a cooler is an easy task that does not require special tools although the water valve needs to have a threaded port for a 1 4 inch water supply tube. And the water had been shut off to the swamp cooler. Tighten any fitting that leaks until it stops.

Which sends water to the cooler without having to manually refill the pan inside the cooler. In it you ll find everything you need to run a poly water supply line to your evaporative cooler. Hooking into a home water line for a swamp cooler can be done a few different ways depending on the placement of a unit and types of water pipes. Connecting a water line to a swamp cooler is an easy job that almost anyone can do.

You will place the nut on first and then a ferrule. Push those back enough so that you can insert a sleeve into the end of the line. A copper line may last longer than plastic. So all that is left to do is to connect the water line from the hose bib to the swamp cooler.

Hi check the float level is 1 2 to 1in below the overflow tube. Either copper or plastic water lines work for a cooler. It is designed with the do it yourselfer in mind.